Engine
Refitting the hub cover bearings
In order to fit the hub box bearings, the engine crankcase and the cover must be heated with the special
heat gun.
- The three 15-mm bearings must be fitted using the appropriate tools:
- The 42-mm side of the adapter must be turned towards the bearing.
Specific tooling
020150Y Air heater mounting
020151Y Air heater
020376Y Adapter handle
020359Y 42 x 47-mm adaptor
020412Y 15-mm guide
NOTE
TO FIT THE BEARING ON THE COVER, ADEQUATELY SUPPORT THE COVER WITH THE STUD
BOLT KIT.
- Refit the driven pulley shaft bearing with a modular punch as shown in the figure.
NOTE
ENG - 116
SR MAX 125 ie