Removing The Oil Sump - APRILIA SR MAX 125 ie Service Station Manual

SR MAX 125 ie
- Make sure the gasket is positioned properly and
refit the pump on the engine crankcase. The pump
can only be fitted in one position. - Tighten the
screws to the prescribed torque.
- Fit the sprocket wheel with a new O-ring.
- Fit the chain.
- Fit the central screw and the cup washer. Tighten
to the prescribed torque.
-Fit the oil pump cover, by tightening the two
screws to the prescribed torque.
NOTE
FIT THE CUP WASHER SO THAT ITS OUTER RIM TOUCH-
ES THE PULLEY. MAKE SURE THAT THE PUMP TURNS
FREELY.
Locking torques (N*m)
Screws fixing oil pump to the crankcase
Oil pump command sprocket screw
pump cover screws
0.7 - 0.9

Removing the oil sump

oil sump
- Drain the oil from the sump.
- Remove the seven screws indicated in the figure
and the bracket of the rear brake pipes.
- Check the correct position of the three alignment
dowels «1» and remove gasket «2», spring and
by-pass piston «3».
5 to 6
Oil
10 to 14
Engine
ENG - 155