APRILIA SR MAX 125 ie Service Station Manual page 226

Suspensions
- Install a new silent bloc, making sure it aligns
properly with the reference tooth.
- Fit the silent blocs, making sure the chamfered
part of the silent bloc matches the chamfered part
of the bracket
- Using the appropriate tool, fit the silent bloc as
shown in the picture
- Check there is no sticking in the movement of the
connection of the swinging arm on the engine side
to the swinging arm on the chassis side.
- Check the axial clearance between the two
swinging arms using a feeler gauge
Characteristic
Standard clearance
0.40 - 0.60 mm
Allowable limit after use:
1.5 mm
- In order to check the clearance of the swinging
arm on the frame side, prepare a retainer using the
fixing pin of the swinging arm on the frame and two
rings from the special tool 020229Y. Alternatively,
use two washers with 12-mm inside diameter for
pins, minimum 30-mm outside diameter and 4-mm
thick at least.
SUSP - 226
SR MAX 125 ie