APRILIA SR MAX 125 ie Service Station Manual page 227

SR MAX 125 ie
Suspensions
- Check there is no sticking in the rotation.
- Check the axial clearance of the swinging arm on
the chassis side
Characteristic
Standard clearance
0.40 - 0.60 mm
Allowable limit after use:
1.5 mm
- Separate the swinging arm on the engine side
from the vehicle side arm.
- Remove the plastic bushings and the internal
spacer shown in the picture.
- Using a suitable pin remove the roller casings as
shown in the pictures
- Using an appropriate tool plant new roller cas-
ings, being careful to position the bearings with the
seal rings facing outwards
Specific tooling
020244Y 15-mm diameter punch
020115Y Ø 18 punch
Characteristic
Length of the swinging arm tube on the engine
side:
L 175.3 + 0.3 0
Length of the internal swinging arm spacer on
the engine side:
L 183 + 0.3 0
SUSP - 227