SR MAX 125 ie
Inspecting the driven sliding half-pulley
- Remove the two seal rings and the two O-rings.
- Measure the movable half-pulley bushing inside
diameter.
- Check the faying surface with the belt to make
sure there are no flaws.
- Check the riveted joints are functional.
- Check the evenness of the belt contact surface.
MOVABLE DRIVEN HALF-PULLEY DIMENSIONS
Specification
Wear limit
standard diameter
maximum allowable diameter
Refitting the driven half-pulley bearing
- Support the pulley bushing adequately from the threaded side using a wooden surface.
- Fit a new roller bearing as shown in the figure.
Desc./Quantity
0.3 mm
Ø 41.000 - 41.035 mm
Ø 41.08 mm
Engine
ENG - 101