Specifying The Actions To Be Taken For Link-Fault Management Events - Juniper EX9200 Features Manual

Related
Documentation

Specifying the Actions to Be Taken for Link-Fault Management Events

Copyright © 2016, Juniper Networks, Inc.
Critical Event
Dying Gasp
Link Fault
The link event TLVs are sent by the remote DTE by means of event notification PDUs.
Link event TLVs are:
Errored Symbol Period Event
Errored Frame Event
Errored Frame Period Event
Errored Frame Seconds Summary Event
IEEE 802.3ah OAM Link-Fault Management Overview on page 3
Configuring IEEE 802.3ah OAM Link-Fault Management on page 5
Enabling IEEE 802.3ah OAM Support on page 6
Configuring Link Discovery on page 16
Configuring the OAM PDU Interval on page 6
Configuring the OAM PDU Threshold on page 7
Configuring Threshold Values for Local Fault Events on an Interface on page 17
Disabling the Sending of Link Event TLVs on page 18
Configuring an OAM Action Profile on page 8
Specifying the Actions to Be Taken for Link-Fault Management Events on page 19
Monitoring the Loss of Link Adjacency on page 12
Monitoring Protocol Status on page 13
Configuring Threshold Values for Fault Events in an Action Profile on page 10
Applying an Action Profile on page 10
Setting a Remote Interface into Loopback Mode on page 11
Enabling Remote Loopback Support on the Local Interface on page 15
Example: Configuring IEEE 802.3ah OAM Support on an Interface on page 21
Ethernet Interfaces Feature Guide for Routing Devices
You can specify the action to be taken by the system when the configured link-fault event
occurs. Multiple action profiles can be applied to a single interface. For each action-profile,
at least one event and one action must be specified. The actions are taken only when all
of the events in the action profile are true. If more than one action is specified, all the
actions are executed.
Chapter 1: Configuring Ethernet OAM Link Fault Management
19