Configuring Ieee 802.3Ah Oam Link-Fault Management - Juniper EX9200 Features Manual

Configuring IEEE 802.3ah OAM Link-Fault Management

Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
You can configure threshold values for fault events that trigger the sending of link event
TLVs when the values exceed the threshold. To set threshold values for fault events on
an interface, include the
event-thresholds
link-fault-management interface]
You can also configure OAM threshold values within an action profile and apply the action
profile to multiple interfaces. To create an action profile, include the
statement at the
[edit protocols oam ethernet link-fault-management]
You can configure Ethernet OAM either on an aggregate interface or on each of its member
links. However, we recommend that you configure Ethernet OAM on the aggregate
interface, and this will internally enable Ethernet OAM on the member links.
To view OAM statistics, use the
mode command. To clear OAM statistics, use the
link-fault-management statistics
management state information and restart the link discovery process on Ethernet
interfaces, use the clear oam ethernet link-fault-management state
command. For more information about these commands, see the
event-thresholds on page 52
action-profile
IEEE 802.3ah OAM Link-Fault Management Overview on page 3
Enabling IEEE 802.3ah OAM Support on page 6
Configuring Link Discovery on page 16
Configuring the OAM PDU Interval on page 6
Configuring the OAM PDU Threshold on page 7
Configuring Threshold Values for Local Fault Events on an Interface on page 17
Disabling the Sending of Link Event TLVs on page 18
Detecting Remote Faults on page 18
Configuring an OAM Action Profile on page 8
Specifying the Actions to Be Taken for Link-Fault Management Events on page 19
Monitoring the Loss of Link Adjacency on page 12
Monitoring Protocol Status on page 13
Configuring Threshold Values for Fault Events in an Action Profile on page 10
Applying an Action Profile on page 10
Setting a Remote Interface into Loopback Mode on page 11
Enabling Remote Loopback Support on the Local Interface on page 15
Chapter 1: Configuring Ethernet OAM Link Fault Management
statement at the
hierarchy level.
show oam ethernet link-fault-management
clear oam ethernet
operational mode command. To clear link-fault
[edit protocols oam ethernet
action-profile
hierarchy level.
operational
operational mode
.
CLI Explorer
5