Juniper EX9200 Features Manual page 20

Network Management and Monitoring Feature Guide for EX9200 Switches
Related
Documentation
4
The features of link-fault management are:
Discovery
Link monitoring
Remote fault detection
Remote loopback
The following features are not supported:
Ethernet running on top of a Layer 2 protocol, such as Ethernet over ATM, is not
supported in OAM configurations.
Remote loopback is not supported on the 10-Gigabit Ethernet LAN/WAN PIC with
SFP+.
The remote loopback feature mentioned in section 57.2.11 of IEEE 802.3ah is not
supported on T4000 routers.
NOTE: Aggregated Ethernet member links will now use the physical MAC
address as the source MAC address in 802.3ah OAM packets.
Configuring IEEE 802.3ah OAM Link-Fault Management on page 5
Enabling IEEE 802.3ah OAM Support on page 6
Configuring Link Discovery on page 16
Configuring the OAM PDU Interval on page 6
Configuring the OAM PDU Threshold on page 7
Configuring Threshold Values for Local Fault Events on an Interface on page 17
Disabling the Sending of Link Event TLVs on page 18
Detecting Remote Faults on page 18
Configuring an OAM Action Profile on page 8
Specifying the Actions to Be Taken for Link-Fault Management Events on page 19
Monitoring the Loss of Link Adjacency on page 12
Monitoring Protocol Status on page 13
Configuring Threshold Values for Fault Events in an Action Profile on page 10
Applying an Action Profile on page 10
Setting a Remote Interface into Loopback Mode on page 11
Enabling Remote Loopback Support on the Local Interface on page 15
Example: Configuring IEEE 802.3ah OAM Support on an Interface on page 21
Ethernet Interfaces Feature Guide for Routing Devices
Copyright © 2016, Juniper Networks, Inc.