Juniper EX9200 Features Manual page 121

Table 8: show interfaces Fast Ethernet Output Fields (continued)
Field Name Field Description
Encapsulation being used on the physical interface.
Link-level type
Maximum transmission unit size on the physical interface.
MTU
Type of link connection configured for the physical interface:
Link-mode
Half-duplex
Speed at which the interface is running.
Speed
Loopback status:
Loopback
or
Local
Source filtering status:
Source filtering
10-Gigabit Ethernet interface operating in Local Area Network Physical Layer
LAN-PHY mode
Device (LAN PHY) mode. LAN PHY allows 10-Gigabit Ethernet wide area links
to use existing Ethernet applications.
WAN-PHY mode 10-Gigabit Ethernet interface operating in Wide Area Network Physical Layer
Device (WAN PHY) mode. WAN PHY allows 10-Gigabit Ethernet wide area links
to use fiber-optic cables and other devices intended for SONET/SDH.
Unidirectional link mode status for 10-Gigabit Ethernet interface:
Unidirectional
Disabled
Flow control status:
Flow control
(Gigabit Ethernet interfaces) Autonegotiation status:
Auto-negotiation
(Gigabit Ethernet interfaces) Remote fault status:
Remote-fault
Online
Offline
Device flags Information about the physical device. Possible values are described in the
"Device Flags" section under Common Output Fields Description.
Information about the interface. Possible values are described in the "Interface
Interface flags
Flags" section under Common Output Fields Description.
Information about the link. Possible values are described in the "Links Flags"
Link flags
section under Common Output Fields Description.
Wavelength (10-Gigabit Ethernet dense wavelength-division multiplexing [DWDM]
interfaces) Displays the configured wavelength, in nanometers (nm).
(10-Gigabit Ethernet DWDM interfaces only) Displays the frequency associated
Frequency
with the configured wavelength, in terahertz (THz).
Copyright © 2016, Juniper Networks, Inc.
or . If loopback is enabled, type of loopback:
Enabled Disabled
.
Remote
or
Enabled Disabled
for parent interface; or
Rx-only
or
Enabled Disabled
—Autonegotiation is manually configured as online.
—Autonegotiation is manually configured as offline.
Full-duplex
.
Enabled
for child interfaces.
Tx-only
.
or
Enabled Disabled
Chapter 8: Operational Commands
Level of Output
All levels
All levels
or
extensive
All levels
All levels
All levels
All levels
All levels
or All levels
All levels
. All levels
All levels
All levels
All levels
All levels
All levels
All levels
105