Juniper EX9200 Features Manual page 128

Network Management and Monitoring Feature Guide for EX9200 Switches
Table 8: show interfaces Fast Ethernet Output Fields (continued)
Field Name Field Description
(10-Gigabit Ethernet interfaces, WAN PHY mode) SONET error information:
WIS section
Seconds
Count
State
Subfields are:
BIP-B1
SEF
LOL
LOF
ES-S
S
ES-S
SEFS-S
(10-Gigabit Ethernet interfaces, WAN PHY mode) Active alarms and defects,
WIS line
plus counts of specific SONET errors with detailed information.
Seconds
Count
State
Subfields are:
BIP-B2
REI-L
RDI-L
AIS-L
BERR-SF
BERR-SD
ES-L
SES-L
UAS-L
ES-LFE
SES-LFE
UAS-LFE
112
—Number of seconds the defect has been active.
—Number of times that the defect has gone from inactive to active.
—State of the error. Any state other than
—Bit interleaved parity for SONET section overhead
—Severely errored framing
—Loss of light
—Loss of frame
—Errored seconds (section)
—Severely errored seconds (section)
—Severely errored framing seconds (section)
—Number of seconds the defect has been active.
—Number of times that the defect has gone from inactive to active.
—State of the error. State other than
—Bit interleaved parity for SONET line overhead
—Remote error indication (near-end line)
—Remote defect indication (near-end line)
—Alarm indication signal (near-end line)
—Bit error rate fault (signal failure)
—Bit error rate defect (signal degradation)
—Errored seconds (near-end line)
—Severely errored seconds (near-end line)
—Unavailable seconds (near-end line)
—Errored seconds (far-end line)
—Severely errored seconds (far-end line)
—Unavailable seconds (far-end line)
OK indicates a problem.
OK indicates a problem.
Copyright © 2016, Juniper Networks, Inc.
Level of Output
extensive
extensive