Juniper EX9200 Features Manual page 112

Network Management and Monitoring Feature Guide for EX9200 Switches
96
—(Optional) Intermediate loose source route entry (IPv4). Open a set
loose-source value
of values.
mac-address mac-address
remote system you are trying to reach.
—(Optional) Do not attempt to determine the hostname that corresponds to
no-resolve
the IP address.
pattern string —(Optional) Specify a hexadecimal fill pattern to include in the ping packet.
—(Optional) Send ping requests rapidly. The results are reported in a single message,
rapid
not in individual messages for each ping request. By default, five ping requests are
sent before the results are reported. To change the number of requests, include the
option.
count
—(Optional) Record and report the packet's path (IPv4).
record-route
routing-instance routing-instance-name
ping attempt.
size bytes —(Optional) Size of ping request packets. The range of values, in bytes, is
through . The default value is
65,468
bytes of ICMP header data are added to the packet.
source source-address —(Optional) IP address of the outgoing interface. This address is
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface (
—(Optional) Use the strict source route option (IPv4).
strict
—(Optional) Intermediate strict source route entry (IPv4). Open a set
strict-source value
of values.
tos type-of-service —(Optional) Set the type-of-service (ToS) field in the IP header of the
ping packets. The range of values is
If the device configuration includes the
class-of-service host-outbound-traffic]
overrides the value specified in this command option. In this case, the ToS field of
ICMP echo request packets sent on behalf of this command carries the DSCP value
specified in the dscp-code-point
specify in this command option.
—(Optional) Time-to-live (TTL) value to include in the ping request (IPv6). The
ttl value
range of values is 0 through
—(Optional) Display detailed output.
verbose
vpls instance-name —(Optional) Ping the instance to which this VPLS belongs.
—(Optional) Maximum wait time, in seconds, after the final packet is sent.
wait seconds
If this option is not specified, the default delay is
without the count option, a default count of
—(Optional) Ping the physical or hardware address of the
—(Optional) Name of the routing instance for the
, which is effectively 64 bytes because 8
56
through
0 255
dscp-code-point value
hierarchy level, the configured DSCP value
configuration statement instead of the value you
255 .
5 packets is used.
).
lo.0
.
statement at the
seconds. If this option is used
10
Copyright © 2016, Juniper Networks, Inc.
0
[edit