Juniper EX9200 Features Manual page 130

Network Management and Monitoring Feature Guide for EX9200 Switches
Table 8: show interfaces Fast Ethernet Output Fields (continued)
Field Name Field Description
Information about link autonegotiation.
Autonegotiation
information
Negotiation status:
Incomplete
No autonegotiation
configured, or does not perform autonegotiation.
Complete
autonegotiation and the autonegotiation process is successful.
Link partner status
performs autonegotiation and the autonegotiation process is successful.
Link partner:
Link mode
either
Flow control
device. For Fast Ethernet interfaces, the type is
interfaces, types are
and transmit),
Symmetric/Asymmetric
transmit or only
Remote fault
indicates a receive link error.
Negotiation error
link partner is going offline.
Local resolution
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
PAUSE
both
Remote fault
receive),
detected on receive).
(10-Gigabit Ethernet interfaces, WAN PHY mode) SONET/SDH interfaces allow
Received path
path trace bytes to be sent inband across the SONET/SDH link. Juniper Networks
trace, Transmitted
and other routing device manufacturers use these bytes to help diagnose
path trace
misconfigurations and network errors by setting the transmitted path trace
message so that it contains the system hostname and name of the physical
interface. The received path trace value is the message received from the routing
device at the other end of the fiber. The transmitted path trace value is the
message that this routing device transmits.
Packet Forwarding Information about the configuration of the Packet Forwarding Engine:
Engine
Destination slot
configuration
114
—Ethernet interface has the speed or link mode configured.
—Remote Ethernet interface has the speed or link mode
—Ethernet interface is connected to a device that performs
— OK when Ethernet interface is connected to a device that
—Depending on the capability of the attached Ethernet device,
or .
Full-duplex Half-duplex
—Types of flow control supported by the remote Ethernet
(link partner supports
Symmetric
(link partner supports
Asymmetric
(link partner supports both
PAUSE receive).
—Remote fault information from the link partner—
OK indicates that the link partner is receiving.
indicates a negotiation error.
—Information from the link partner:
—Types of flow control supported by the remote Ethernet
PAUSE on receive and transmit),
on transmit), and Symmetric/Asymmetric
on receive and transmit or only
PAUSE
—Remote fault information.
(local interface is offline), and
Offline
—FPC slot number.
. For Gigabit Ethernet
None
on receive
PAUSE
on transmit), and
PAUSE
on receive and
PAUSE
Failure
Offline indicates that the
Symmetric (link partner
Asymmetric (link partner supports
(link partner supports
receive).
PAUSE
(no error detected on
Link OK
(link error
Link Failure
Copyright © 2016, Juniper Networks, Inc.
Level of Output
extensive
extensive
extensive