Table 9: Show Interfaces Gigabit Ethernet Output Fields - Juniper EX9200 Features Manual

Table 9: show interfaces Gigabit Ethernet Output Fields

Field Name Field Description
Physical Interface
Physical interface Name of the physical interface.
State of the interface. Possible values are described in the "Enabled Field"
Enabled
section under Common Output Fields Description.
Index number of the physical interface, which reflects its initialization sequence.
Interface index
SNMP index number for the physical interface.
SNMP ifIndex
Unique number for use by Juniper Networks technical support only.
Generation
Encapsulation being used on the physical interface.
Link-level type
Maximum transmission unit size on the physical interface.
MTU
Speed at which the interface is running.
Speed
Loopback Loopback status:
or
Local
Source filtering status:
Source filtering
10-Gigabit Ethernet interface operating in Local Area Network Physical Layer
LAN-PHY mode
Device (LAN PHY) mode. LAN PHY allows 10-Gigabit Ethernet wide area links
to use existing Ethernet applications.
10-Gigabit Ethernet interface operating in Wide Area Network Physical Layer
WAN-PHY mode
Device (WAN PHY) mode. WAN PHY allows 10-Gigabit Ethernet wide area links
to use fiber-optic cables and other devices intended for SONET/SDH.
Unidirectional Unidirectional link mode status for 10-Gigabit Ethernet interface:
Disabled
Flow control Flow control status:
Auto-negotiation (Gigabit Ethernet interfaces) Autonegotiation status:
Remote-fault (Gigabit Ethernet interfaces) Remote fault status:
Online
Offline
Device flags Information about the physical device. Possible values are described in the
"Device Flags" section under Common Output Fields Description.
Information about the interface. Possible values are described in the "Interface
Interface flags
Flags" section under Common Output Fields Description.
Copyright © 2016, Juniper Networks, Inc.
Enabled or Disabled . If loopback is enabled, type of loopback:
.
Remote
or
Enabled Disabled
for parent interface; or
Rx-only
Enabled or Disabled
—Autonegotiation is manually configured as online.
—Autonegotiation is manually configured as offline.
.
Enabled
for child interfaces.
Tx-only
.
Enabled or Disabled
Chapter 8: Operational Commands
Level of Output
All levels
All levels
none
detail extensive
none
detail extensive
detail extensive
All levels
All levels
All levels
All levels
All levels
All levels
All levels
or All levels
All levels
. All levels
All levels
All levels
All levels
121