Juniper EX9200 Features Manual page 141

Table 9: show interfaces Gigabit Ethernet Output Fields (continued)
Field Name Field Description
Total number of ingress queues supported on the specified interface. Displayed
Ingress queues
on IQ2 interfaces.
Queue counters CoS queue number and its associated user-configured forwarding class name.
(Ingress) Displayed on IQ2 interfaces.
Queued packets
Transmitted packets
Dropped packets
Active alarms and Ethernet-specific defects that can prevent the interface from passing packets.
When a defect persists for a certain amount of time, it is promoted to an alarm.
Active defects
Based on the routing device configuration, an alarm can ring the red or yellow
alarm bell on the routing device, or turn on the red or yellow alarm LED on the
craft interface. These fields can contain the value
None
Link
unplugged, the far-end system has been turned off, or the PIC is
malfunctioning.
Active OTN alarms identified on the interface.
OTN alarms
OTN defects received on the interface.
OTN defects
OTN FEC Mode The FECmode configured on the interface.
efec
correct bit errors.
gfec
and correct bit errors.
none
OTN Rate OTN mode.
fixed-stuff-bytes
no-fixed-stuff-bytes
pass-through
no-pass-through
OTN Line Loopback Status of the line loopback, if configured for the DWDM OTN PIC. Its value can
be: enabled
OTN FEC statistics The forward error correction (FEC) counters for the DWDM OTN PIC.
Corrected Errors
Corrected Error Ratio
example, 1e-7 is 1 error per 10 million bits.
Copyright © 2016, Juniper Networks, Inc.
—Number of queued packets.
—Number of transmitted packets.
—Number of packets dropped by the ASIC's RED mechanism.
—There are no active defects or alarms.
—Interface has lost its link state, which usually means that the cable is
—Enhanced forward error correction (EFEC) is configured to defect and
—G.709 Forward error correction (GFEC) mode is configured to detect
—FEC mode is not configured.
—Fixed stuff bytes 11.0957 Gbps.
—No fixed stuff bytes 11.0491 Gbps.
—Enable OTN passthrough mode.
—Do not enable OTN passthrough mode.
or disabled .
—The count of corrected errors in the last second.
—The corrected error ratio in the last 25 seconds. For
Chapter 8: Operational Commands
or .
None Link
Level of Output
extensive
extensive
detail extensive none
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
125