Juniper EX9200 Features Manual page 150

Network Management and Monitoring Feature Guide for EX9200 Switches
Table 9: show interfaces Gigabit Ethernet Output Fields (continued)
Field Name Field Description
Number and rate of bytes and packets transiting the switch.
Transit statistics
NOTE:
interface egress statistics might not accurately reflect the traffic on the wire
when output shaping is applied. Traffic management output shaping might
drop packets after they are tallied by the
interface counters. However, correct values display for both of these egress
statistics when per-unit scheduling is enabled for the Gigabit Ethernet IQ2
physical interface, or when a single logical interface is actively using a shared
scheduler.
Unique number for use by Juniper Networks technical support only.
Generation
Route table in which the logical interface address is located. For example,
Route Table
refers to the routing table inet.0.
Information about protocol family flags. Possible values are described in the
Flags
"Family Flags" section under Common Output Fields Description.
Donor interface (Unnumbered Ethernet) Interface from which an unnumbered Ethernet interface
borrows an IPv4 address.
(Unnumbered Ethernet) Secondary IPv4 address of the donor loopback interface
Preferred source
that acts as the preferred source address for the unnumbered Ethernet interface.
address
Names of any input filters applied to this interface. If you specify a precedence
Input Filters
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Output Filters Names of any output filters applied to this interface. If you specify a precedence
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Number of MAC address validation failures for packets and bytes. This field is
Mac-Validate
displayed when MAC address validation is enabled for the logical interface.
Failures
Information about the address flags. Possible values are described in the
Addresses, Flags
"Addresses Flags" section under Common Output Fields Description.
protocol-family Protocol family configured on the logical interface. If the protocol is
address of the interface is also displayed.
Flags Information about address flag (possible values are described in the "Addresses
Flags" section under Common Output Fields Description.
IP address of the remote side of the connection.
Destination
IP address of the logical interface.
Local
Broadcast address of the logical interlace.
Broadcast
134
For Gigabit Ethernet intelligent queuing 2 (IQ2) interfaces, the logical
Output bytes and Output packets
inet
Copyright © 2016, Juniper Networks, Inc.
Level of Output
extensive
detail extensive
none
0 detail extensive
detail extensive
detail extensive none
none
detail extensive
detail extensive
detail extensive
none
detail extensive
none
detail extensive
, the IP brief
detail extensive none
none
detail extensive
none
detail extensive
none
detail extensive