Oki MC853 User Manual page 1006

Address Information
Lock Time Out
USB Memory
Interface
Panel Brightness
During Operating
Panel Brightness
While Power Save
Panel Calibration
Output Tray Paper
Exist Lamp
Power Save Power Save Time
Sleep Time
Auto Power Off Time
Silent Mode
ECO Mode*
Memory Receive Buffer Size
Setup
Resource Save
Flash Initialize
Memory
Setup*
1
HDD Initialize
Setup*
1
Format
Partition
Storage Check File System
Maintenance
Setup
Check All Sectors
30
minute(s)
Enable
7
0
Execute
Enable
1 minute
15 minutes
4 hours
ON
ON
1
Auto
OFF
Execute
Execute
PCL (NULL)
Common (NULL)
PS (NULL)
Execute
Execute
Sets time until a lock is released by the
machine when an address book, telephone
book, or profile is kept locked by the utilities.
Available range: 1 to 60 minutes
If [Disable] is set, the Scan To USB Memory
and the print from USB Memory functions
cannot be used.
Sets the LCD panel brightness.
Available range: 1 to 7 (1 increments)
Sets the LCD panel brightness.
Available range: 0 to 7 (1 increments)
Executes LCD panel calibration.
Selects whether to flash LED when paper
remains on the Upper Output Tray.
Only for the models mounted the Upper
Output Tray.
Sets when to enter Power Save mode.
Sets when to enter Sleep mode.
Sets when to enter Auto Power Off.
Specifies a print preparation operation when
entering standby status from Sleep mode.
If [ON] is set: it is quiet as there is no print
preparation.
If [OFF] is set: there is a rotation noise of the
image to perform print preparation but you
can start first printing early.
If [ON] is set: Printing starts even before the
temperature of the fuser reaches the
prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the
temperature of the fuser reaches the
prescribed degrees.
Sets the reception buffer size that local
interface secures.
Sets the resource save area.
Initializes a flash Memory.
Display condition: [Initial Lock] is set to
[Disable].
Initializes a hard disk.
Display condition: [Initial Lock] is set to
[Disable].
Formats a partition.
Resolves any mismatch between actual
Memory and displayed Memory available in a
file system and performs administration data
(FAT information) recovery.
Performs recovery of a defective HDD sector
1005