In The Case Of The Fx 3Uc -32Mt-Lt - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
1.10.2 In the case of the FX
Confirm the number of units using the following procedures.
Division
A
Expansion boards
B
Special adapter
C
I/O extension devices
D
Special function devices
- Special function units
- Special function blocks
56
-32MT-LT
3UC
Only 1 unit can be connected.
B1
Up to four units can be connected.
Analog
When the expansion board is the FX
B2
connected. When the expansion board is not the FX
Communication
be connected.
• When the FX
Up to 7 special function units/blocks in total can be connected in each system
when the main unit is the FX
connectable units is restricted in some models (as shown below).
• When the FX
Note that the number of connectable units is restricted in some models (as
shown below). (When further connection is required, use the FX
The number of units connectable to the main unit or extension power supply unit
is restricted in the following models.
Model name
FX -16EYR-T
2NC
FX -8ER
2N
FX -8EYR
2N
FX -8EYT
2N
FX -8EYT-H
2N
FX -8ER
0N
FX -8EYR
0N
FX -8EYT
0N
FX -8EYT-H
0N
FX -16EYR
0N
FX -16EYT
0N
FX -16EYR
2N
FX -3A
0N
FX -2AD
2N
FX -2DA
2N
*1. Adding more extension power supply units enables connection of 6 or more
units.
*2. Consider the restriction for the number of special extension equipment.
The number of units connectable to the main unit or extension power supply unit
is restricted for the following models.
Model name
FX -16CCL-M
2N
FX -32ASI-M
2N
FX -16LNK-M
2N
FX -1RM-SET
2N
1.10 Restriction in number of units in each group
Contents of restrictions
-1PS-5V is used
3UC
-1PS-5V is not used
3UC
Connection target and number of connectable units
A
FX -32MT-LT
3UC
*1
A
Only either 1 unit can be
connected to the FX
32MT-LT.
*2
*2
*2
• It cannot be used together with FX
• When some units are used, a remote I/O station cannot
be connected to the second and following master
stations.
It cannot be used together with FX
- Only one unit can be used for the whole system.
It is not supported by the FX
Up to 3 units can be sequentially connected to the end of a
system. However, when three units are connected, they are
counted as one unit, and the number of input/output
occupied points is 8.
-CNV-BD, up to 2 units in total can be
3U
-CNV-BD, only 1 unit can
3U
-32MT-LT. Note that the number of
3UC
E
FX
3UC
E
Up to 5 units in total can be
- connected to the extension
3UC
power supply unit.
Restrictions
-32ASI-M.
2N
-16CCL-M.
2N
-32MT-LT.
3UC
1 Outline
-1PS-5V.)
3UC
-1PS-5V