Setting Dip Switches In Built-In Master (Operation Mode/Communication Speed/Point Mode) - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
9.9.1 Setting DIP switches in built-in master (operation mode/Communication speed/
Point mode)
1
Turn the power OFF
2
Remove the display module of the FX
3
Setting the TEST mode Transmission speed and Point mode
B RATE (Transmission speed) setting [DIP switch 1, 2]
DIP switch status
1
OFF
ON
OFF
ON
16pts/4pts (Point mode) setting [DIP switch 3]
DIP switch status
3
ON
OFF
4
Setting the CONFIG mode
Set the operation mode to "CONFIG".
Selecting the Operation mode [DIP switch 6, 7]
DIP switch status
6
OFF
ON
OFF
[DIP switch 4, 5, 8]
The DIP switches 4, 5 and 8 are unavailable. Make sure to set them to OFF.
1. Setting example of transmission speed (B RATE), point mode (16 pts/4 pts) and operation
mode
Set the DIP switches as shown in the right figure to set the following
status.
Item
B RATE
16pts/4pts
operation mode
Set the station number of remote I/O units in reference to Subsection
9.9.2.
→ For the display module removal method, refer to Section 3.8.
Setting Content
2
OFF 156kbps
OFF 625kbps
ON 2.5Mbps
ON Prohibited to use
Setting Content
16-point mode
4-point mode
Setting Content
7
OFF ONLINE mode
OFF CONFIG mode
ON TEST mode
Setting Content
2.5Mbps
4-point mode
CONFIG mode
9 CC-Link/LT Built-in master ability (Only FX3UC-32MT-LT)
9.9 Setting of CC-Link/LT built-in master and remote I/O units
-32MT-LT.
3UC
DIP switch
6 = ON
DIP switch
2 = ON
1
2
3
4
5
6
7
8
9
10
281