Requirement For Compliance With Lvd Directive - Mitsubishi FX3UC SERIES User Manual

Requirement for Compliance with LVD directive

The following products have shown compliance through direct testing (of the identified standards below) and
design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (73/23/EEC) when used as directed by the appropriate documentation.
Type :
Models :
from August 1st, 1999
from October 1st, 2007
IEC1010-1:1990
/A1:1992
BSEN61010-1 :1993
*1. Compliance to BSEN61010-1 is claimed through virtue of direct compliance to IEC1010-1 and
Amendment 1.
Models :
from July 1st, 1997
from August 1st, 2005
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2003
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
EN61131-2:1994 Programmable controllers
/A12:1996 - Equipment requirements and tests
/A11:2000
EN61131-2:2003 Programmable controllers
Programmable Controller (Open Type Equipment)
MELSEC FX series manufactured
2NC
FX -16EYR-T-DS
2NC
FX -16EYR-T
2NC
Standard
Safety requirements for electrical
equipment for measurement,
control, and laboratory use
- General requirements
*1
MELSEC FX series manufactured
2N
FX -16EYR-ES/UL
2N
FX -8ER-ES/UL
2N
Standard
and laboratory use
- General requirements
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
FX -8EYR-ES/UL
2N
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:1994+A11:1996+A12:2000
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2003
Remark
Remark
17