Appendix A-2-7 Cautions On Using Transparent Port (2-Port) Function Of Got-F900 Series - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition

Appendix A-2-7 Cautions on using transparent port (2-port) function of GOT-F900 Series

When monitoring circuits, device registration, etc. in an FX
using the transparent (2-port) function in the GOT-F900 Series, make sure to execute the following setting.
• If the following setting is not provided, monitoring cannot be executed normally.
• This setting is not necessary when the FX
monitoring without using the transparent function of the GOT-F900 Series.
When using transparent
function in GOT-F900
Series
When directly
connecting GX Developer
to PLC
*1. GX Developer Ver.8.13P or later supports the FX
Setting in GX Developer (Ver.8.13P or later)
1
Select [Online] → [Transfer setup...] to open the "Transfer Setup" dialog box.
2
Double-click [PLC module] in [PLC side I/F] to open the [PLC side I/F Detailed
setting of PLC module] dialog box.
3
Put a check mark to the check box [via GOT-F900 transparent mode] as
shown below.
4
Click the [OK] button to finish the setting.
GX Developer
Ver.8.12N or earlier
Setting shown below is
required.
Set "COM port" and "Transmission speed" on "PC
side I/F Serial setting" dialog box.
Double-click it.
A Version Information and Peripheral Equipment Connect ability
PLC from GX Developer Ver. 8.13P or later
3UC
Series PLC is directly connected to GX Developer for
3UC
GX Developer
*1
Ver.8.13P or later
Setting shown below is
not required.
Series.
3UC
A-2 Programming Tool Applicability
GX Developer Ver.8.22Y or later
Select "RS-232C" on "PC side I/F
Serial setting" dialog box, and
execute setting shown below.
Select "RS-232C" on "PC side I/F
Serial setting" dialog box, and set
"COM port" and "Transmission
speed."
Put a check mark to the
check box "via GOT-F900
transparent mode."
11
12
A
B
C
D
E
F
419