Language (Menu Display Language Setting); Changing To Japanese Menus - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
10.8

LANGUAGE (Menu Display Language Setting)

The language used at the display module menus is specified at the "LANGUAGE" menu. The language
setting procedure is described below.
All operation explanations and display screen examples in this manual are in Japanese. When the menu
display language is set to English, please convert the screen messages to their English translations.
→ Refer to Section 10.23 for the Japanese & English display character correspondence table.

10.8.1 Changing to Japanese menus

The procedure for changing from English menus to Japanese menus is described below.
1) Turn the PLC power on.
Following a brief title screen display (1.5 seconds), the "Main unit
I/O operation display" or a "user message" is displayed.
2) Press the [OK] button to display the menu screen shown to the right
(4 lines of the menu display).
3) At the menu screen, use the [+]/[-] buttons to move the cursor to the
"LANGUAGE" item, then press [OK] to display the "display
language selection screen".
To cancel the operation and return to the "Main unit I/O operation
display", press [ESC].
334
10 Display Module (Only FX3UC-32MT-LT)
10.8 LANGUAGE (Menu Display Language Setting)
Title screen
ME L S E C - F
F X 3 U C - 3 2 M T - L T
V e r . 1 . 0 0
Main unit I/O operation display
X 0 0 0
X 1 0 0
Y 0 0 0
Y 1 0 0
or
User creation screen (example)
< P r o d u
T a r g e t
P r o d u c
R e m a i n
M o n i t o r / T e s t
E r r o r C h e c k
L A N GU A G E
C o n t r a s t
C l o c k M e n u
E n t r y C o d e
C l e a r A l l D e
P L C S t a t u s
S c a n T i m e
C a s s e t t e
L A N G U G A E
E n g i l s h
Approx.
1.5 secs.
c t i o n >
1 0 0 0 0
t i o n 1 0 0
i n g 9 9 0 0
v