Procedures For Removal From Din Rail; Direct Mounting (Fx 0N /Fx 2N /Fx 3U Extension Units/Blocks) - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
2. FX /FX Series I/O extension block, FX
0N 2N
1) Push the DIN rail mounting hook of the I/O extension block for the FX
(except 8-point type I/O extension blocks) as shown in
the right.
This step is not required in I/O extension blocks for FX
function blocks for FX
2) Align the upper side of the DIN rail mounting groove with the DIN rail
the figure on the right).
3) Press the product onto the DIN rail as shown in
4) The extension cable is connected.
For the connection method of the extension cable, refer to Section 3.4.
3.3.2

Procedures for removal from DIN rail

1) Disconnect connection cables such as power cables, I/O cables, CC-Link/
LT connection cables and extension cables.
2) Hook a slotted screwdriver to the DIN rail mounting hook
the right).
3) Move the slotted screwdriver in the direction
mounting hooks from all connected units/blocks, and let the DIN rail
mounting hooks come off the DIN rail.
4) Remove the main unit from the DIN rail
5) Push the DIN rail mounting hooks as shown in
This step is not required in I/O extension blocks for FX
function blocks for FX
3.3.3 Direct mounting (FX
Only I/O extension blocks for FX
installed directly. Install them with screw holes M4 in reference to "2.1 External Dimensions (MASS/
Installation/Accessories)". Assure the space of 1 to 2mm(0.04" to 0.08") between units as shown below.
108
/FX /FX .
0N 2N 3U
in the figure on the right).
/FX /FX .
0N 2N 3U
/FX /FX extension units/blocks)
0N 2N 3U
/FX and special function units/blocks for FX
0N 2N
FX
3UC
FX -
2NC
Series
32EX
Main unit
DIN rail
Extension cable
•FX
-65EC
0N
•FX
-30EC
0N
FX
2N-
16EX
FX -CNV-BC
2N
3 Generic Specifications/Installation Work
3.3 Procedures for Installing on and Detaching from DIN Rail
/FX /FX Series special function unit/block
0N 2N 3U
in the figure on
and special
0N
in the figure on the right.
in the figure on
, pull out the DIN rail
in the figure below.
/FX and special
0N 2N
FX -CNV-IF
2NC
or
FX -1PS-5V
3UC
1 to 2mm (0.04" to 0.08")
FX
2N-
10PG
(+ indicates an M4 screw.)
2N
Rear panel
in
/FX /FX can be
0N 2N 3U