Specifying A Hexadecimal Current Value Display Format; System Information - Specifying A Hexadecimal Current Value Display Format; Program Example 1 (Specifying A Hexadecimal Data Display Format); Program Example 2 (Specifying A Decadal Data Display Format) - Mitsubishi FX3UC SERIES User Manual

Hide thumbs Also See for FX3UC SERIES:
Table of Contents

Advertisement

FX
Series Programmable Controllers
3UC
User's Manual - Hardware Edition

10.18 Specifying a Hexadecimal Current Value Display Format

The procedure for specifying a hexadecimal display format for current values which display at the "Monitor/
Test" menu explained below. The display format is specified by the system information's (system signal 2)
"M
+ 5" ON/OFF status.
The display formats which correspond to the ON and OFF statuses are shown in Subsection 10.18.1 below.
The display format should either be fixed as decimal or hexadecimal. Switching between the two should be
possible by an external operation.

10.18.1 System information - specifying a hexadecimal current value display format

1. System signal 1
System signal 1 is unrelated to this function.
2. System signal 2
System
Information
M
+ 5

10.18.2 Program example 1 (specifying a hexadecimal data display format)

The following program example specifies a hexadecimal display format for current values and setting values
which display at the "Monitor/Test" screen. In this program example, system information is assigned from D50
to D90 and from M50 to M56.
M8002
Initial pulse
M8000
RUN monitor

10.18.3 Program example 2 (specifying a decadal data display format)

The following program example specifies a decimal display format for current values and setting values which
appear at the "Monitor/Test" screen. In this program example, system information is assigned from D50 to
D90 and from M50 to M56.
M8002
Initial pulse
M8000
RUN monitor
356
Setting
Display
Content
Format
Hexadecimal Timer (T) [current value], counter (C) [current value], data register (D) [16-
ON
bit/32-bit], extended register (R) [16-bit/32-bit], and extended file register
OFF
Decimal
(ER) [16-bit/32-bit]
MOV
K50
D8300
MOV
K50
D8301
M55
END
MOV
K50
D8300
MOV
K50
D8301
M55
10 Display Module (Only FX3UC-32MT-LT)
10.18 Specifying a Hexadecimal Current Value Display Format
→ Refer to Section 10.16 for system information setting.
Display Subjects
System information (system No.1) is set at D50 to D90.
System information (system No.2) is set at M50 to M56.
Specifies a hexadecimal display format for current values which appear
at the Monitor/Test screen.
System information (system No.1) is set at D50 to D90.
System information (system No.2) is set at M50 to M56.
Specifies a decimal display format for current values which appear at
the Monitor/Test screen.

Advertisement

Table of Contents
loading

Table of Contents