Mitsubishi FX3UC SERIES User Manual page 280

FX FX Series Programmable Controllers Series Programmable Controllers
3UC 3UC
User's Manual - Hardware Edition User's Manual - Hardware Edition
2. Attachment procedure
The procedure is shown below.
1) Terminal processing procedure
1) Properly place the dedicated
flat cable in the cover.
(Check that the position of
the orange part is correct.)
Orange
Note1) This setting position is
wrong.
2) T-branch processing procedure
5) Cut 2 portions of the edge of
the cover with nippers and
remove the edge.
274
2)
Orange
Cut
9 CC-Link/LT Built-in master ability (Only FX3UC-32MT-LT)
9.8 Connection of Cables, Connectors and Terminating Resistors
Close the cover so that the
flat cable will be held between
both sides of the cover
Orange
Note2) If the orange part is seen
through the guide hole in
the front cover, the wiring
is not correct. Open the
cover and perform the
previous step again.
Orange
6) Set the cover to the point
where the T-branch is to be
set.
Orange
3) Assemble the cover with the
body and press-fit them with
pliers.
Orange
4) Check that all four latches
are engaged.
Press-fitting is completed.
Orange
7) Follows the instructions of
steps 3 and 4 shown above
to execute press-fitting.
Orange