Expansion Module For Ip Phones - Avaya 1110 Fundamentals

TFTP Server
7. The phone reads the configuration file from the TFTP server, extracts the Server_IP
8. The display shows [FW] writing... and the blue LED starts to flash.
9. After the FW image is written to the phone, the message [FW] Finished is
10. If the IP Phone remains in this condition because no TPS FW download occurs,

Expansion Module for IP Phones

The Avaya 1100 Series Expansion Module (Expansion Module) uses the same TFTP Server
configuration file method as the Avaya 1100 Series IP Deskphones.
Table 140: Fields in the TFTP configuration file for the Expansion Module
describes the fields in the configuration file on the TFTP Server. The section [GEM FW]
indicates the firmware is for the Expansion Module. Set the download mode to AUTO or
FORCED. It is recommended that you set DOWNLOAD_MODE to AUTO.
Table 140: Fields in the TFTP configuration file for the Expansion Module
Field Name
[GEM FW]
DOWNLOAD_MODE
VERSION
638 IP Deskphones Fundamentals
(.) in the IP address. You can also use the backspace key to erase part of the
address or correct errors by pressing soft key 1 (BKSpace). When the address
is correct, press soft key 1 (OK).
and Filename fields, and attempts to download the file. The display shows the
message [FW] reading...
displayed, the blue LED stops flashing, and the phone resets.
The phone registers to the TPS with the new FW version.
If the TFTP Server, specified by the TFTP IP address entered during configuration,
is unreachable or down, the IP Phone attempts to register to the TPS to perform a
firmware download. If the IP Phone does not register to the TPS, the IP Phone does
not work. Check the TFTP IP address and the state of the TFTP Server, then reboot
the IP Phone.
check the TFTP IP address and the state of the TFTP Server, then restart the IP
Phone.
Field Value
AUTO
FORCED
Comments? infodev@avaya.com
Descriptions
Section header for the Expansion Module
firmware download information.
Recommended setting. The application
looks at the version and downloads the FW
if it is a newer version than the one on the
phone.
The version of firmware is ignored. The
firmware is always downloaded.
The version string compared to the one on
the phone.
on page 638
February 2013