Installation - Avaya 1110 Fundamentals

Avaya 1200 Series LCD Expansion Module

Installation

The LCD Expansion Module mounts on the right side of the IP Phone. The LCD Expansion
Module snaps into the receptacle on the back of the IP Phone using the desk-mount bracket
and structural base plate supplied with the LCD Expansion Module.
The LCD Expansion Module connects to the IP Phone using the Accessory Expansion Module
(AEM) port on the IP Phone.
Use Connecting the Avaya 1200 Series LCD Expansion Module to the IP Phone
to connect the LCD Expansion Module.
Caution:
Damage to Equipment
To avoid damaging the equipment, remove the power (PoE cable, or local power) from the
IP Phone before connecting the LCD Expansion Module.
Connecting the Avaya 1200 Series LCD Expansion Module to the IP Phone
1. Remove the IP Phone from the stand by pulling the IP Phone away from the
2. Remove the rubber cap from the AEM port.
3. Attach the ribbon cable from the LCD Expansion Module to the IP Phone and the
4. If connecting a second, third, or fourth LCD Expansion Module, repeat steps 2 to
5. Attach the IP Phone stand and the LCD Expansion Module stand, if removed. Adjust
6. Reconnect the local power or PoE cable to the Avaya 1200 Series IP
124 IP Deskphones Fundamentals
stand.
AEM port.
4.
The second LCD Expansion Module is attached to the right side of the first LCD
Expansion Module. The third LCD Expansion Module is attached to the right side
of the second LCD Expansion Module. The fourth LCD Expansion Module is
attached to the right side of the third LCD Expansion Module.
each LCD Expansion Module stand to the same angle as the IP Phone.
Deskphones.
The LCD Expansion Module powers up. The LCD Expansion Module uses the
electrical connection of the Avaya 1220 IP Deskphone or Avaya 1230 IP Deskphone
for power. It does not have its own power source.
Comments? infodev@avaya.com
on page 124
February 2013