Avaya 1110 Fundamentals page 96

Avaya 1220 IP Deskphone
3. Connect the headset (optional):
4. Connect the global power supply (optional).
5. Install the Ethernet cable. Connect one end of the supplied Ethernet cable to the
6. Connect the other end of the cable to your LAN Ethernet connection. The LAN LED
7. If you connect your PC through the phone, a second CAT5-e cable is required. Only
96 IP Deskphones Fundamentals
a. Plug the end of the handset cord with the short straight section into the
handset.
b. Plug the other end of the handset cord with the long straight section into
the handset jack marked with the handset symbol on the back of the IP
Phone.
c. Thread the cord through the channel in the footstand (if installed) so that
it exits on the side of the foot stand (optional).
a. Plug the headset cord into the headset jack on the back of the IP Phone
marked with the headset symbol.
b. Thread the cord through the channel in the side of the foot stand.
c. Set up the headset according to the instructions included with the
headset.
The Avaya 1220 IP Deskphone supports both AC power and Power over LAN
options, including IEEE 802.3af Power Classification 2. To use PoE, where power
is delivered over the CAT5-e cable, the LAN must support PoE, and the global power
supply is not required. To use local AC power, you can order the optional global
power supply separately.
Warning:
Use your Avaya 1220 IP Deskphone with the approved Avaya global power
supply (model number NTYS17xxE6).
The Avaya 1220 IP Deskphone supports both AC power and PoL options,
including IEEE 802.3af Power Classification 2.
a. Connect the Direct Current (DC) barrel connector to the power jack on
the back of the IP Phone.
b. Thread the cable through the channel in the foot stand to secure the
cable.
c. Plug the country-specific IEC cable into the global power supply, and
then plug the global power supply into the nearest AC power outlet.
back of your phone using the CAT5-e connector (LAN Ethernet port), and thread
the network cable through the channel in the footstand.
on the back of the IP Phone lights when a LAN connection is established.
one cable is included with the Avaya 1220 IP Deskphone package. Install the
Ethernet cable connecting the PC to the phone (optional). Connect one end of the
PC Ethernet cable to your phone using the CAT5-e connector (PC Ethernet port),
and thread it through channel in the footstand. Connect the other end to the LAN
connector on the back of your PC.
Comments? infodev@avaya.com
February 2013