Avaya 1110 Fundamentals page 310

Avaya 1100 Series Expansion Module
2. At the back of the IP Phone, remove the rubber plug from the Accessory Expansion
3. Insert the screws in to the top and bottom holes of the connecting arm of the
310 IP Deskphones Fundamentals
Figure 64: Adjusting the stand angle on the IP Phone
Module (AEM) port. Place the connecting arm of the Expansion Module behind the
IP Phone and align the Expansion Module connection plug to the AEM port on the
back of the IP Phone.
Expansion Module and tighten until snug. See
Module on page 311.
Comments? infodev@avaya.com
Figure 65: Connecting the Expansion
February 2013