Avaya 1110 Fundamentals page 606

IP Phone diagnostic utilities
6. The number of hops for the Tracert command is shown on the screen. The default
7. Press the Ping soft key to have the IP Phone attempt to access the IP address, up
8. To stop the ping before completing, press the Stop soft key. When finished, the
9. Use the Up and Down navigation keys to scroll the results screen. Press the Back
10. Press the Tracert soft key to request the IP Phone to trace the route to the Host IP
606 IP Deskphones Fundamentals
To change the number of repetitions, navigate to the item, press Enter to edit the
item. Input a new value using the dialpad and press Enter.
is 30.
To change the number of hops, navigate to the item, press Enter to edit the item.
Input a new value using the dialpad and press Enter.
to the Number of Pings value.
The IP Phone displays the following
Pinging x.x.x.x with 64B (where x.x.x.x is the Host IP address)
The IP Phone attempts to contact (ping) the address the number of configured
times, and displays the results of each attempt.
phone displays the following:
• Packets transmitted ( Tx )
• Packets received ( Rx )
• Percentage of Packets Lost ( Lost )
• Minimum round trip time ( Min )
• Maximum round trip time ( Max )
• Average round trip time ( Average )
Figure 108: Ping results
Diagnostic Tools ping test.
Figure 108: Ping results
softkey to return to the parameter input screen or Cancel to return to the Diagnostics
menu.
address, up to the Maximum Hops node count.
Comments? infodev@avaya.com
on page 606 shows the Output screen for the Network
February 2013