Avaya 1110 Fundamentals page 637

TFTP Server, and you must manually configure the phone to point to that TFTP Server. The
BootC firmware carries out the upgrade. To initiate the firmware download task, BootC must
be triggered to run.
You can create the configuration file with a default file name, such as 1140E.img so you do not
have to change the file name each time a new Avaya 1140E IP Deskphone firmware load is
released. However, if you take this approach, be sure to rename the released firmware file (for
example, 0625Cxx.bin) to the default file name when the new firmware file is copied into the
TFTP Server root directory and to update the VERSION string in the configuration file.
After the configuration file and the image file are in the TFTP Server root directory, use
Upgrading the firmware using BootC
Upgrading the firmware using BootC
1. Hold down the [Up] and [2] keys, and while doing so, repower the phone. When the
2. The following text menu on a white background appears:
3. When Avaya appears on the screen, press the soft keys 1,2,3,4 in sequence (left
4. Follow the prompts to configure DHCP and other IP parameters or, if DHCP and
5. When prompted: TFTP Dwnld? (0-No, 1-Yes):0:
6. When prompted: TFTP IP xxx.xxx.xxx.xxx:
IP Deskphones Fundamentals
phone restarts, it loads and runs BootC instead of the application. When the Msg
Waiting LEDs go off, you can release the [Up] and [2] keys.
11x0 IP Phone Manual Configuration Avaya
If you do not see this message, you are in the wrong menu. Repeat step 1. If BootC
is damaged from a power reset, hold down the [Up] and [3] keys to use the backup
BootC.
to right). BootC goes to manual configuration. If you miss this step, and the phone
begins to register to the TPS, repeat step 1.
other parameters are already configured, just continue pressing the 1 soft key or
OK. The soft keys functions are listed below:
• soft key 1 (below the LCD) is OK
• soft key 2 is Backspace
• soft key 3 is Clear
• soft key 4 is Cancel
• Press soft key 2 (BKSpace) to clear the 0 (No).
• Press 1 on the dialpad, then press soft key 1 (OK).
• If the IP address is correct for the TFTP server, press soft key 1 (OK). After
the TFTP address is entered the first time, it is presented the next time you
enter the menu.
• If the IP address is incorrect, press soft key 2 (Clear) to erase the address
shown and enter a new address. Press the asterisk (*) key to enter a period
on page 637 to upgrade the firmware using BootC.
Updating IP Phones firmware
February 2013 637