Startup Sequence - Avaya 1110 Fundamentals

9. Replace the stand cover. Ensure that all cables are neatly routed and press the
10. If you wall-mount the phone, put it in the wall-mount position by holding the tilt lever
When you complete the IP Phone connection, you must connect the phone to the network.
See Dynamic Host Configuration Protocol

Startup sequence

When an Avaya 1120E IP Deskphone connects to the network, it must perform a startup
sequence. The elements of the startup sequence include
• obtaining network access (if supported by the network infrastructure)
• obtaining VLAN ID (if supported by the network infrastructure)
• obtaining the IP parameters
• obtaining the provisioning parameters
• connecting to the Call Server
The IP Phone is configured for automatic provisioning by default. For more information about
provisioning the IP Phone automatically, see
You can manually configure all or some parameters. For information about manually
provisioning the IP Phone, see
1100 Series IP Deskphones
IP Deskphones Fundamentals
or Method B—using the traditional-style wall-mount box with a CAT5-e connector
and a 15 cm (6 inch) CAT5-e cord (not provided).
• Method A: Press the wall-mount lever, and pull away from the stand. Using the
stand cover (see step 2), mark the wall-mount holes by pressing the bottom of
the stand cover firmly against the wall in the location where you wish to install
the phone. Four small pins on the bottom of the stand cover make the marks
on the wall. Use the marks as a guideline to install the wall-mount screws (not
provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the wall, and then
install the phone stand mounting holes over the screw heads. You may need
to remove the phone from the wall to adjust the lower screws. When the lower
screws are snug, install the phone on the mounting screws, and then tighten
the top screws.
• Method B: Attach the 15 cm (6 inch) CAT5-e cable, position the stand over the
mounting rivets, and slide the phone down the wall so that the rivets fit into the
slots on the stand.
stand cover into place until you hear a click.
and press the phone towards the base until the phone is parallel with the base.
Release the tilt lever and continue to push the phone towards the base until you
hear a click. Ensure the phone is securely locked in to position.
Manual provisioning of Avaya 2007 IP Deskphone and Avaya
on page 503.
on page 373.
Provisioning the IP Phones
Installation and configuration
on page 443.
February 2013 237