Connecting The Components - Avaya 1110 Fundamentals

2. Configure the Avaya 1140E IP Deskphone on the Call Server using LD 11. At the
3. Configure the Avaya 1140E IP Deskphone in Element Manager. IP Phones are

Connecting the components

Use Connecting the components
Caution:
The Avaya 1140E IP Deskphone is shipped with the stand locked in position. To avoid
damaging the IP Phone, press the wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone.
Connecting the components
1. Press the wall-mount lever located under the Handsfree key to release the stand
IP Deskphones Fundamentals
For more information about configuring a virtual loop, see Avaya Signaling Server
IP Line Applications Fundamentals, NN43001-125 and Avaya Software Input
Output Reference-Administration, NN43001-611.
prompt, enter the following
REQ: new TYPE: 1140
For more information about configuring the Avaya 1140E IP Deskphone using LD
11, see Avaya Software Input Output Reference-Administration, NN43001-611.
configured using the Phones section in the Element Manager navigation tree. For
more information about configuring the Avaya 1140E IP Deskphone using Element
Manager, see Avaya Element Manager System Reference - Administration ,
NN43001-632.
and pull it away from the phone. See
Deskphone from the stand
on page 253 to connect the components for the IP Phone.
Figure 45: Release the Avaya 1140E IP
on page 254.
Installation and configuration
February 2013 253