Avaya 1110 Fundamentals page 236

Avaya 1120E IP Deskphone
5. Install the Ethernet cable. Connect one end of the supplied Ethernet cable to the
6. If you are connecting your PC through the phone, a second CAT5-e cable is
7. Connect additional cables. If applicable, plug in optional USB devices. Connect the
8. Wall-mount your phone (optional). Use Method A or Method B to wall-mount the IP
236 IP Deskphones Fundamentals
Figure 42: Cable routing tracks
back of your phone using the CAT5-e connector (LAN Ethernet port), and thread
the network cable through the channel (LAN Ethernet port).
required. Only one cable is included with the Avaya 1120E IP Deskphone package.
Install the Ethernet cable connecting the PC to the phone (optional). Connect one
end of the PC Ethernet cable to your phone using the CAT5-e connector (PC
Ethernet port), and thread it through the channel. Connect the other end to the LAN
connector on the back of your PC.
The LAN Ethernet port supports Auto-Media Dependent Interface Crossover
(MDIX). Auto-MDIX is supported only when the Ethernet port is configured for
autonegotiation. The PC Port does not support Auto-MDIX.
Caution:
Damage to Equipment
Do not plug any device into your Avaya 1120E IP Deskphone Ethernet port other
than an IEEE 802.3 Ethernet network connection.
Ethernet cable to the LAN Ethernet connection. If you are using a global power
supply, plug the adapter into an AC outlet.
Complete steps 1 to 7, as needed, before wall-mounting the IP Phone.
Phone. See Method A—using the mounting holes on the bottom of the phone stand,
Comments? infodev@avaya.com
February 2013