6.9
Adjustment of the Scanner Section
6.9.1
Carriages
[A] Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Wire pulley
[Rear side]
Idler pulley
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the
carriage wires by the tension springs.
Notes:
Make sure the tension applied to the wire is normal.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Tension spring
Fig.6-31
Carriage-2
Tension spring
Fig.6-32
6 - 53
Idler pulley
Carriage wire
Bracket for carriage-1
Hook
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
Wire pulle
SETTING / ADJUSTMENT
6