Poor Fusing - Toshiba e-STUDIO206L Service Manual

8.4.6

Poor fusing

Defective area
Heater electric power
Pressure between fuser
roller and pressure roller
Fuser roller temperature
Developer material/Toner
Paper
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig.8-7
Step Check items
1 Check if the connector contacts
properly.
2 Is the heater shorted or broken?
3 Are the pressure springs working
properly?
4 Is the temperature of the fuser roller
normal?
5 Using the specified developer
material and toner?
6 Is the paper in the drawer or LCF
damp?
7 Is the paper type corresponding to its
mode?
8 Is the setting temperature of the fuser
roller in each paper type normal?
9 Using the recommended paper?
8 - 297
Prescription
Correct it.
Replace the heater.
Check and adjust the pressure
springs.
Check the setting and correct it.
08-2120, 2010, 2009, 2140, 515, 516
(08-5285: Only e-STUDIO356/456/
506 / e-STUDIO357/457/507)
Use the specified developer material
and toner.
Avoid storing paper in damp place.
Use the proper type of paper or
select the proper mode.
Check the setting and correct it.
08-2028, 2049, 2050, 2051,2141,
2142, 2143, 2192, 2194, 2195)
(08-5328, 5329, 5330, 5331, 5332: e-
STUDIO356/456/506 / e-
STUDIO357/457/507)
Use the recommended paper.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
8