Center / Side / Edge Thermistor (Thms1/Thms2/Thms3) - Toshiba e-STUDIO206L Service Manual

4.13.6

Center / Side / Edge thermistor (THMS1/THMS2/THMS3)

(1) Take off the fuser roller unit
( P. 4-112 "4.13.2 Fuser roller unit /
Pressure roller unit").
(2) Place the fuser roller unit [1] upside down.
(3) Remove 2 screws, and then take off the
harness cover [2].
Notes:
When installing the harness cover [2], make
sure that the harness is not caught.
(4) Take out the thermistor by removing 1 screw
each.
Notes:
1. When installing the thermistors, check the
length of the harness first and distinguish
the installation positions of the side
thermistor and edge thermistor by the
length of each harness.
2. When installing, be careful not to deform
the thermistor. Also, make sure that the
thermistor is in touch with the fuser roller.
Notes:
When installing the thermistors, check the
length of the harness first and distinguish the
installation positions of the side thermistor
and edge thermistor by the length of each
harness.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[1]
Fig. 4-332
Edge thermistor
Side thermistor
Fig. 4-333
Edge thermistor
Fig. 4-334
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 117
[2]
Thermistor
Center
thermistor
Side thermistor
Center thermistor
DISASSEMBLY AND REPLACEMENT
4