3.9
Adjustment of the Scanner Section
3.9.1
Carriages
(1)
Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Wire pulley
[Rear side]
Idler pulley
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the
carriage wires by the tension springs.
Note:
Note:
Make sure the tension applied to the wire is normal.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Tension spring
Fig. 3-14
Carriage-2
Carriage wire
Tension spring
Fig. 3-15
3 - 49
Idler pulley
Bracket for carriage-1
Hook
Wire pulley
e-STUDIO281c/351c/451c
ADJUSTMENT
3