Scan Motor (M1) - Toshiba e-STUDIO206L Service Manual

4.6.8

Scan motor (M1)

(1) Take off the upper rear cover.
 P. 4-12 "4.2.7 Upper rear cover"
(2) Remove 2 screws, disconnect 1 connector
[1] and take off the scan motor assembly [2].
Notes:
When installing the scan motor, use the belt
tension jig.
(3) Remove 2 screws and take off the scan
motor [1].
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Fig. 4-144
Fig. 4-145
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 50