General Precautions Regarding The Service For This Equipment; Transportation/Installation - Toshiba e-STUDIO206L Service Manual

GENERAL PRECAUTIONS REGARDING THE SERVICE FOR
THIS EQUIPMENT
The installation and service shall be done by a qualified service
technician.

1. Transportation/Installation

- When transporting/installing the equipment, employ two persons and be sure to hold the
positions as shown in the figure.
The equipment is quite heavy, and weighs approximately 61 kg (134.51 lb.), therefore pay full
attention when handling it.
- Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when
transporting the equipment.
- Be sure to use a dedicated outlet with AC 110 V / 13.2 A, 115 V or 127 V / 12 A, 220-240 V or 240
V / 8 A for its power source.
- The equipment must be grounded for safety.
- Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and
direct sunlight.
- Provide proper ventilation since the equipment emits a slight amount of ozone.
- To insure adequate working space for the copying operation, keep a minimum clearance of 80
cm (32") on the left, 80 cm (32") on the right and 10 cm (4") on the rear.
- The equipment shall be installed near the socket outlet and shall be accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over
it.
- When the equipment is used after the option is removed, be sure to install the parts or the covers
which have been taken off so that the inside of the equipment is not exposed.
- Do not lift the machine by the areas in the figure that are shaded when lifting it.