Pfp Lower Drawer Misfeeding - Toshiba e-STUDIO206L Service Manual

Parts to be replaced
Pickup roller
[E160] PFP lower drawer misfeeding (paper not reaching the PFP lower drawer feed sensor)
Classification
Paper misfeeding
Proce
Check item
dure
1 Open the PFP side cover.
Is there any paper in front
of the PFP lower drawer
feed sensor?
2 Is the PFP lower drawer
feed sensor working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[3]/[B])
3 Is the PFP lower drawer
feed clutch working?
(Perform the output check
in the test mode: 03-228)
4 PFP lower drawer feed
roller
Separation roller
Pickup roller
Parts to be replaced
PFP lower drawer feed sensor.
PFP board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Jam not reaching the PFP lower drawer feed sensor
Result
Yes Remove the paper.
No
Yes
No • Check if the connector of the PFP lower
drawer feed sensor is disconnected.
• Check if either of the connectors CN241 or
CN243 on the PFP board is disconnected.
• Check if the connector CN318 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and LGC board are short circuited or
open circuited.
• Replace the PFP lower drawer feed sensor.
• Replace the PFP board.
• Replace the LGC board.
Yes
No • Check if the connector of the PFP lower
drawer feed clutch is disconnected.
• Check if any of the connectors CN241 and
CN248 on the PFP board is disconnected.
• Check if the connector CN318 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and LGC board are short circuited or
open circuited.
• Replace the PFP lower drawer feed clutch.
• Replace the PFP board.
• Replace the LGC board.
• Check the PFP lower drawer feed roller,
separation roller and pickup roller.
Replace them if they are worn out.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 64
Remark
Error content
Measure
Remark
Next
Step
2
3
4