Toshiba e-STUDIO206L Service Manual page 506

[B] Confirmation of the number of punch holes registered
(1) Turn OFF the power of the equipment.
(2) Take off the rear cover of the finisher.
(3) Set the bits 1, 2 and 4 of the DIP switch [2] on the hole punch control PC board (HP) [1] to ON.
Then turn ON the power of the equipment while pressing the push button switch [3] on the hole
punch control PC board (HP) [1] and the digital keys [0] and [8] on the control panel of the
equipment.
(4) Set only the bit 2 of the DIP switch [2] to ON.
(5) LEDs [4] on the hole punch control PC board (HP) [1] start blinking by pressing the push button
switch [3]. The number of punch holes registered can be confirmed with the number of blinking.
(Count the number of blinks in the second round and after, as the first round includes the first
blink.)
See the table below for the number of punch holes registered.
(6) Turn OFF all bits of the DIP switch [2].
(7) Install the rear cover of the finisher.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
[1]
CPU
[2]
ON
1 2 3 4
Fig.6-146
Number of punch holes
2 holes (E)
2/3 holes (N)
4 holes (F)
4 holes (S)
6 - 126
[4]
LED
[3]
Number of LED Blinking
4
9
7
8
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved