Jam Not Reaching The Reverse Sensor; Stop Jam At The Reverse Sensor - Toshiba e-STUDIO206L Service Manual

[E570] Jam not reaching the reverse sensor
[E580] Stop jam at the reverse sensor
Classification
Paper transport jam
Proce
Check item
dure
1 Checking of paper
2 Is the reverse sensor
working? (Perform the
input check in the test
mode: 03-[FAX]ON/[9]/[C])
3 Is the reverse motor
working? (Perform the
output check in the test
mode: 03-123/173)
Parts to be replaced
Reverse sensor
LGC board
Exit roller
Reverse motor
MOT2 board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Error content

Jam not reaching the reverse sensor

Stop jam at the reverse sensor

Result
• Open the ADU and remove paper if there is
any on the transport path.
* If the error still occurs, check the following:
Yes
No - Check if the connector pins are
disconnected or the harnesses are open
circuited between the reverse sensor
and the connector CN304 on the LGC
board. Correct if there is any
abnormality.
- Replace the reverse sensor.
- Replace the LGC board.
Yes Check the exit roller. Replace it if it is worn out.
No • Check if the connector pins are
disconnected or the harnesses are open
circuited between the reverse motor and the
connector CN304 on the LGC board (and
also the connectors CN401 and CN406 on
the MOT2 board). Correct if there is any
abnormality.
• Replace the reverse motor.
• Replace the MOT2 board.
• Replace the LGC board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 53
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8