Output Check (Test Mode 03); Test Print Mode (Test Mode 04) - Toshiba e-STUDIO206L Service Manual

5.4

Output Check (Test Mode 03)

Status of the output signals can be checked by inputting in the following codes in the test mode 03.
Operation procedure
Procedure 1
[0][3]
(Code) [START]
[POWER]
Procedure 2
[0][3]
(Code)
[POWER]
Procedure 3
[0][3]
(Code) [START]
[POWER]
Procedure 4
[0][3]
[POWER]
Procedure 5
[0][3]
(Code)
[POWER]
* Return to the standby screen for code input by pressing the [CLEAR] button.
5.5

Test Print Mode (Test Mode 04)

The embedded test pattern can be printed out by keying in the following codes in the test print mode
(04).
Operation procedure
[0][4]
(Code)
[POWER]
Notes:
1. When an error occurs, it is indicated on the panel, but the recovery operation is not
performed. Turn OFF the power and then back ON to clear the error.
2. During test printing, the [CLEAR] button is disabled when "Wait adding toner" is displayed.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Operation Stop
ON code
Operation
[START]
One direction
Operation
[START]
ON
(Code)
[START] [Digital keys]
[START] Operation
Continuous
Test Printing
5 - 9
Operation
[START]
OFF
Test mode
[CLEAR]
standby
Operation
[CLEAR]
OFF
[POWER] OFF
[START]
[START]
[START]
[CLEAR] [POWER] OFF/ON
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
[POWER] OFF/ON
(Exit)
[POWER] OFF/ON
(Exit)
[POWER]
Test mode
OFF/ON
standby
(Exit)
[POWER] OFF/ON
(Exit)
(Exit)
SELF-DIAGNOSIS MODES
5