Fuser Roller - Toshiba e-STUDIO206L Service Manual

4.13.4

Fuser roller

(1) Take off the separation fingers
( P. 4-113 "4.13.3 Separation finger").
(2) Remove 6 screws and take off the fuser
roller and three heater lamps.
Notes:
1. Be careful not to deform the fuser roller
by pushing strongly.
2. When installing the heater lamps, refer to
the installation procedure.
( P. 4-115 "4.13.5 Heater lamp")
3. For e-STUDIO206L/256/306 / 207L/257/
307, the sub heater lamp is not installed.
4. When installing the fuser roller, be careful
not to deform the thermistor.
5. When installing the fuser roller, confirm
that the drive gears are engaged.
(3) Remove 1 C-ring and 1 bearing from the
fuser roller front side.
(4) Remove 1 C-ring, 1 gear and 1 bearing from
the fuser roller rear side.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Fuser roller
C-ring
Bearing
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 114
White(M4)
Blue
Center
Sub
White(M3)
Side
Fig. 4-326
Bearing
Gear
C-ring
Fig. 4-327