About Each Mode - Toshiba e-STUDIO206L Service Manual

[E] About each mode
• Control panel check mode (01)
Operation procedure
[0][1] LED lit/
[POWER] LCD blinking
Notes:
• The mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
• Button Check
Press the buttons with LED to turn OFF the LED.
Press the buttons without LED to display the message on the control panel.
Press the button on touch panel to display the screen on the control panel at power-ON.
Press [execution] on the touch panel and then the [CLEAR] button on the control panel.
The screen then returns to the Button Check menu.
• Test mode (03)
Refer to the following.
 P. 5-8 "5.3 Input Check (Test Mode 03)"
 P. 5-9 "5.4 Output Check (Test Mode 03)"
• Test print mode (04)
Refer to the following.
 P. 5-9 "5.5 Test Print Mode (Test Mode 04)"
• Adjustment mode (05)
Refer to the following.
 P. 5-10 "5.6 Operation Procedure in Adjustment Mode (05)"
• Setting mode (08)
Refer to the following.
 P. 5-12 "5.8 Operation Procedure in Setting Mode (08)"
• Assist mode (3C)
Refer to the following.
 P. 5-14 "5.9 Assist Mode (3C)"
• HDD assist mode (4C)
Refer to  P. 5-17 "5.10 HDD Assist Mode (4C)".
• File system recovery mode (5C)
Refer to the following.
 P. 5-21 "5.11 File System Recovery Mode (5C)"
• SRAM clear mode (6C)
Refer to  P. 5-26 "5.12 SRAM Clear Mode (6C)".
• List print mode (9S)
Refer to the following.
 P. 5-28 "5.13 List Print Mode (9S)"
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[START] (Button check)
[START]
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
5 - 3
[POWER] OFF/ON
(Exit)
SELF-DIAGNOSIS MODES
5