Drive Gears In The Paper Feeding Section - Toshiba e-STUDIO206L Service Manual

* j, l. Drive gears in the paper feeding section (teeth of gears and shafts)
Apply some white grease (Molykote EM-30L) to the teeth of gears and shafts of the drive gears.
When disassembling the driving section and applying grease at PM, follow the notes as below.
Main motor drive unit
Registration
roller (metal)
Leaf spring
B
Registration
roller (metal)
A: Do not apply grease to the installation section of the registration roller clutch. Wipe off any grease.
B: Do not wipe off the conductive grease applied to the contact section of the leaf spring and the
registration roller (metal).
C: Do not apply grease to gear teeth which contact the registration roller clutch gear.
D: Apply a blob of grease (the size of a rice grain) to the gear teeth of the registration roller clutch. Be
careful not to use too much.
E: Do not apply grease to the side of the registration roller clutch gear. Wipe off any grease.
Notes:
Make sure that oil is not running over or scattered around as the gear is rotated coming into the
clutch after applying Molykote to the gear which is located near the clutch. The quantity of
Molykote should be smaller than that to be applied to the other parts.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Registration
roller clutch
Registration roller clutch
A
approx.50mm
Fig. 7-15
7 - 21
Timing belt
Leaf spring
Registration roller clutch
D
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
PREVENTIVE MAINTENANCE (PM)
C
E
7