4.6.11
Carriage wire, carriage-2
[A] Carriage wire, carriage-2
(1)
Remove carriage-1.
P. 4-52 "4.6.10 Carriage-1"
(2)
Move carriage-2 to the center.
(3)
Attach the wire holder jig [2] to the wire
pulley [1] to prevent the wire from coming
loose.
Notes:
1. When attaching the wire holder jig [1],
make sure that the wire has not shifted or
become loose.
2. The wire should come out of the slot of
the wire holder jig [1] and be passed
under the jig arm [2].
3. When installing the wire holder jig, be
careful of the orientation.
(4)
Remove the tension springs [1] in the front
and rear sides.
(5)
Remove the carriage wire [2].
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-156
[1]
Fig. 4-157
Fig. 4-158
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 55
[2]
[1]
DISASSEMBLY AND REPLACEMENT
4