Toshiba e-STUDIO206L Service Manual page 282

(5) Remove 4 screws and the take off the ADU
lower guide.
(6) Remove 1 clip and take off the gear unit.
(7) Disconnect 1 connector and remove 4
screws, and the take off the ADU upper
guide.
(8) Remove 2 clips, 1 bushing, 1 gear, 1 pin and
the ground plate. Then take off the ADU
upper transport roller.
Notes:
When installing the gear, insert the pin in the
roller shaft and fit it in the groove of the gear.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
ADU lower
guide
Gear unit
ADU upper transport roller
Gear Pin
Ground plate
Bushing
Clip
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 142
Connector
Fig. 4-401
Clip
Fig. 4-402
Connector
ADU upper guide
Fig. 4-403
Clip
Bushing
Fig. 4-404