Primary Scanning Data Laser Writing Start Position At Duplexing; Adjustment For Long-Sized Paper; Adjustment For Short-Sized Paper - Toshiba e-STUDIO206L Service Manual

[E] Primary scanning data laser writing start position at duplexing
Notes:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1]

Adjustment for long-sized paper

<Procedure>
While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
(1)
Press [3]  [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
(2)
drawer (Refer to *).
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)  (Key in code [4019])  [START]  [0]  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] or [INTERRUPT] (Stored in memory)
 "100% A" is displayed.
 Press [3]  [FAX](A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
[E-2]

Adjustment for short-sized paper

<Procedure>
While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
(1)
Press [3]  [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
(2)
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)  (Key in the code [4019])  [START]  [1]  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] or [INTERRUPT] (Stored in memory).
 "100% A" is displayed
 Press [3]  [FAX]  (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
6 - 12