Toshiba e-STUDIO206L Service Manual page 916

(6) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button.
If the screen for notifying a failure of the performance is displayed, quit this operation by pressing
the [CLOSE] button. Then check that the one-time dongle, which you used for uploading the
selected license, is installed in the equipment.
(7) Check that the returned license is not displayed on the screen.
Remarks:
If there are any other licenses to be returned, repeat from step (4).
If there are no other licenses to be returned, press the [CLOSE] button, and then turn the power
OFF.
(8) Replace the equipment.
(9) Turn the power ON while pressing [0] and [8] simultaneously.
(10) Key in [3840], and then press the [START] button.
(11) Press the [INSTALL] button.
(12) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(13) Select the license to be installed, and then press the [INSTALL] button.
(14) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(15) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(16) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (11). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 40